Acrylic Feeder
2010/07/16 22:26
I bought Acrylic Feeder (right). I used left picture feeder but it is easy to drop from glass so I decided to change the acrylic one. This Acrylic Feeder is well built.
I can attatch this to rimmed glass with acrylic screw and the diameter is wide enough that fish can eat their food easily.
One of my regret in this is not installed to parallel to glass. If the screw is near the diameter a little bit, I may be satisfied.
"My Equipment" 카테고리의 다른 글
- New Project about LED spot lighting (댓글 2개 / 트랙백 0개) 2008/02/27
- New Resin (댓글 0개 / 트랙백 0개) 2011/01/17
- DIY frag station (댓글 0개 / 트랙백 0개) 2008/09/21
- Carbon phospate Test Part1 (댓글 0개 / 트랙백 0개) 2008/11/15
- Vortech (댓글 0개 / 트랙백 0개) 2007/01/21
- Octopus Skimmer. (댓글 0개 / 트랙백 0개) 2006/12/30
- PH Calibration in AquaController Jr (댓글 5개 / 트랙백 0개) 2009/11/13
- Profilux Dosing Pump (댓글 4개 / 트랙백 0개) 2009/08/31
- Aquasun and GE6500 (댓글 0개 / 트랙백 0개) 2009/09/14
- Mag Float met Easy Blade (댓글 2개 / 트랙백 0개) 2008/09/21
Trackback Address:http://spsholic.com/trackback/329
저 보기 싫은 마크만 어떻게 제거 되면 저도 하나 사볼텐데요 ㅎㅎㅎ
나도 떼어보려고 했는데 안되더라구 ㅎㅎㅎㅎ